SYSOP Mode

To set the following 3 highlighted commands, you need to connect via radio a local K-Net node and then connect to the K-Net node you want to change. AT the CMD: type SYSOP and then you will need the converted sysop password

1. Connect to a local Node  (CMD: C CALLSIGN-8)

2. Hit the ENTER key (for the menu) and type SYSOP or type SYSOP and enter

3. Enter the password

4. Enter the following 3 highlighted commands:

       

       IDINT 21

       NODESINT 20

  INFO & CTEXT are commands that will display your information.

5. Connect to your local Node and then back to your Node. Then type SYSOP and do the password authorization.

   You will see ACCESS GRANTED

6. Now you can enter INFO and what you want it to say. Once you have enter INFO or CTEXT just type it and enter to make sure it what you like.

       INFO CRD K-net Node stack VE7CRP-7 on 145.690 <--> VE7CRP-6 on 440.125 at 1000 ft on Mt. Matheson

7. Once you are finnished send the BYE command to disconnect.

Note: INFO information can be shown when you connect to a Node and type INFO.